ModelPowerBoat.com - View Single Post

dwbr22387 · 01-13-2010, 07:16 PM

hi mate,
got your answer yet?
I'm new here but can help with that.
you will need two esc - one for each motor- and a v-tail mixer. this then wires one to the throttle and one to the rudder ch on the reciever. (this gives independant motor control)
if you have a rudder servo and a spare ch you could move the rudder servo to a different ch........depends on you tx for control simplicity....
the esc 's should be reversable.......try car type if marine will not reverse, this will also depend on your tx.....
works well for aircraft but that did not require reverse :-)

regards
don

01-13-2010, 07:16 PM	#2 (permalink)
dwbr22387 Junior Member Join Date: Jan 2010 Location: BRISTOL, UK Posts: 5 Downloads: 16 Uploads: 0	hi mate, got your answer yet? I'm new here but can help with that. you will need two esc - one for each motor- and a v-tail mixer. this then wires one to the throttle and one to the rudder ch on the reciever. (this gives independant motor control) if you have a rudder servo and a spare ch you could move the rudder servo to a different ch........depends on you tx for control simplicity.... the esc 's should be reversable.......try car type if marine will not reverse, this will also depend on your tx..... works well for aircraft but that did not require reverse :-) regards don Last edited by dwbr22387; 01-13-2010 at 07:20 PM.